Waterproofing Materials Suppliers in Navi Mumbai | Jay Ambe Petrochem And Infra

Tips For Waterproofing Suppliers

There are some compounds, which are used in plastic concrete to make it less permeable to water. These compounds are known as integral waterproofing compounds. Selecting the correct type of protection and being sure you have made the right choice can be a difficult process.

If entire wall surfaces are wet, however, you’ll need to do further sleuthing. To conduct a simple condensation test, dry an area of the wall with a rag and then attach a one-foot square piece of aluminum foil to the wall with duct tape. 

A waterproofing membrane is a layer of water-tight material that is laid onto a surface to prevent water leaks or damage. Waterproofing membranes generally consist of liquid applied or pre-formed sheet membranes.

They can be adhered to or installed around the foundations to prevent water penetration. Clean and dampen the horizontal open surface, 15 cm above the highest ground level nearby.

They are based on plasticizing and air-entrainment or water repellence principles. These are used as a good waterproofing precaution when other factors such as good mix-design, proper mixing/placing, compacting/curing, etc are taken care of. This subject of integral waterproofing compounds requires in-depth discussion hence will not be taken up here. 

The Basement and the Foundation are the places that require the most attention because water can cause major problems. Water can crawl into wall spaces and create a wet damp condition causing molds. This leads to an unpleasant foul smell inside the building. If this issue is left unattended, waterlogging scenario.

During a rainy season, a crack in a basement wall can allow an inch or two of water in, but before you seek to repair the crack, remove all the water from the floor. Working in a flooding basement increases the risk of electrical shock or electrocution.